Step by step directions to gluing inner corners

When finishing, the main problem can be irregular walls and the consequent folds on the background. It’s also necessary to take into consideration that when the walls are crookedthe joints of wallpaper canvases might invisibly.

After gluing the last one in the front of the interior corner of the cloth must measure the remaining space. It is measured from the edge of the pasted cloth to the adjoining wall, so the resulting figure is inserted 10-15 millimeters. When the walls are extremely curved, the additional figure may be more.

Cut a strip equal to the resulting figure, taking into consideration the allowance. The surfaces have been treated with adhesive. Depending on the sort of coat it may be exactly the wall or surfaces.

The strip has been glued independently with the cut side into the wall. The wallpaper should go on the opposite airplane.

In case the glued wallpaper is wrinkled, you want to make several small cuts perpendicular to the springs.

Level or slope on the adjoining wall is a vertical lineup. The distance from the corner is equal to the diameter of the prior cut strip, not adding developments.

The surfaces have been smeared with glue, and the coating is glued into the wall using the flat side into the marked line. The cut side goes on the adjacent wall.

Protruding corner ought to be glued by analogy using an interior, however there are little differences, which also need to be taken into account when working.

Measured the space remaining in the glued background into the adjoining wall. Add 20-25 millimeters to the captured figure.

A segment is cut off, taking into account the additional 20-25 millimeters.

Before gluing, the surfaces are treated with adhesive.

The even edge has to be glued to the background already fixed onto the wall, your own cut “extends” into the next plane. If necessary, small cuts are created in the area of visiting another background, smoothed and pushed into the wall.

Draw a vertical strip on the adjoining wall at a distance of only glued cut strip and 6-10 millimeters.

After applying the glue, the strip is applied to the wall with its flat side to the marked line, moving over the edge of the already glued strip.

The joints have been smeared with glue and ironed using a rollercoaster. After that, the top layer is cut along the ruler and the two layers are combined together.